Adjustments, 1 installation check, 2 exchanging display unit of previous model – Furuno 1712 User Manual

Page 16: 3 adjustments, 1) adjustment of picture

Advertising
background image

10

3. ADJUSTMENTS

3.1 Installation Check

After installing the system it is a good idea to
check it for proper installation, following the
checklist provided below.

❒ Cable gland is facing toward the stern.

❒ Four fixing bolts securing the antenna unit

are securely tightened.

❒ The signal cable is waterproofed at the base

of the antenna unit.

❒ The antenna cable is securely retained

against the mast or mounting and is free of
interference from running rigging.

❒ The cable gland on the deck or bulkhead is

waterproofed, if provided.

❒ Connectors of external equipment are

securely plugged into the radar display unit.

❒ The power connections to the battery are of

correct polarity.

3.2 Exchanging Display
Unit of Previous Model

When exchanging the display unit of the
MODEL 1712 with that of the MODEL 1622 or
1621/1621 MARK-2, it is necessary to select
the appropriate display setting. This should be
done with the radar in stand-by.

1. Press

%

and

&

together for about 10

seconds to show the display shown in
Figure 20.

NAV DATA (NMEA 0183)

GLL

BWR

BWC

GLC

GTD

RMA

RMB

RMC

VTG

MTW

DBT

DBS

DPT

GGA

PROGRAM NO
03591620XX

SEL MENU
BY KEY

MAIN

DEMO

/

MODEL

1712

1622 1621/M2

DISPLAY

1

2

Figure 20 Maintenance menu

2. Select MODEL by

%

.

3. Select 1622 or 1621/M2 by



.

4. Press the [MENU] key to close the menu.

3.3 Adjustments

Do the following in order to adjust the radar.

1) Adjustment of picture

1. Press the [POWER] key on the display unit.

The display should light. In approximately
one minute, ST-BY appears at the screen
center.

2. When ST-BY appears press the [TX] key.

The radar will start transmitting, and you
will probably see some targets, even
though the radar is not yet properly
adjusted.

3. Adjust the GAIN to display a small amount

of noise on the screen.

4. Press the [–] key several times to select

the minimum range. Adjust the STC to
display nearby radar targets clearly on the
screen. Too much STC action will eliminate
small targets, and too little STC action will
cause the screen to be so full of targets
and noise that it is hard to determine which
target is which as compared to visual
sightings.

Advertising