FUJITSU V1010 - Manual (Page 45)

40 - Starting Your LifeBook Notebook
Boot Sequence
The procedure for starting-up your notebook is termed the Bootup sequence and involves your notebook’s
BIOS. When your LifeBook notebook is first turned on, the main system memory is empty, and it needs
to find instructions to start up your notebook. This information is in the BIOS program. Each time you
power up or restart your notebook, it goes through a boot sequence which displays a Fujitsu logo until
your operating system is loaded. During booting, your notebook is performing a standard boot sequence
including a Power On Self Test (POST). When the boot sequence is completed without a failure and
without a request for the BIOS Setup Utility, the system displays the operating system’s opening screen.
The boot sequence is executed when:
• You turn on the power to your LifeBook notebook.
• You restart your notebook from the Windows Shut Down dialog box.
• The software initiates a system restart. Example: When you install a new application.
Hard Disk Drive Passwords
To provide additional security for your data, you can assign passwords to your hard disk drive(s). This
feature is managed in the system BIOS Setup Utility. See BIOS Setup Utility below for information about
accessing the utility.
N EVER TURN OFF YOUR L IFE B OOK NOTEBOOK DURING THE P OWER O N S ELF T EST (POST) OR IT WILL
CAUSE AN ERROR MESSAGE TO BE DISPLAYED WHEN YOU TURN YOUR L IFE B OOK NOTEBOOK ON THE
NEXT TIME . See “Power On Self Test Messages” on page 89.
R EMEMBER YOUR PASSWORDS . I F YOU SET AND FORGET YOUR U SER AND M ASTER HARD DISK
PASSWORDS , F UJITSU C OMPUTER S YSTEMS WILL NOT BE ABLE TO RESET IT . Y OU MAY LOSE DATA AND
HAVE TO REPLACE YOUR SYSTEM BOARD OR HARD DISK DRIVE .