Fisher-Price BARBIE JAMMIN' JEEP H3427 - Manual (Page 12)

H3427a-0920
17
16
12
ASSEMBLY F
H3427a-0920
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through the slot
near the outer edge of the seat. Make sure the side of the seat belt
with the fastener faces the outer edge of the seat.
• Pull the short seat belt strap completely through the slot until the
last T-loop at the opposite end of the belt catches against the slot.
You will pull one T-loop through the slot.
• Repeat this procedure to assemble the other short seat belt strap.
Short Seat
Belt Strap
Fastener End
Seat
Slot
T-Loops
Slot
T-Loop (Pull through slot)
14
Spacers
Grille
• Fit two spacers between the grille and the back of the brush guard,
as shown
A
.
• Insert two #8 x 3" screws through the inside of the headlight, the
spacers and into the holes in the grille B . Tighten the screws.
• Insert each fastener end of the long seat belt strap through a slot in
the center of the seat. Make sure the fasteners face the outer edge
of the seat.
• Pull each side of the long seat belt strap evenly through the slots.
Make sure to pull each T-loop through a slot.
• Turn the seat upright.
T-Loop
Fastener End
Long Seat Belt Strap
15
Brush Guard
• Fit the light covers to the headlights.
• Insert #10 x
1 /
2
" screws into the light covers. Tighten the screws.
Light
Covers
A
B #8 x 3" Screws
Headlights