Festool OF 1400 EQ - Manual (Page 11)

11
a) Copying ring
12.3
12.4
12.1
12.2
Secure the copying ring (12.1) to the router
base by inserting both tenons (12.2) into
the recesses (12.3).
To loosen the copying ring, press both but-
tons (12.4) inwards simultaneously.
When choosing the size of the
copying ring make sure that the cutter used
fi ts through the ring’s opening.
The distance Y between the workpiece and
template is calculated by
Y
Y = 1/2 (Ø copying ring - Ø cutter)
b) Copying device
The angle arm WA-OF and copier scanning set
KT-OF, consisting of roller holder (13.5) and
three copying rollers (13.6), are required for
the copying device.
13.6
13.5
13.1
13.4
WA-OF KT-OF
13.3
13.2
Screw the angle arm at the desired height
in the platen’s threaded bore (13.1) with
the rotating knob (13.2).
–
–
–
Fit a copying roller in the roller holder and
bolt this to the angle arm with the rotating
knob (13.4). Make sure that the copying
roller and cutter have the same diameter!
Turn the adjusting wheel (13.3) to adjust
the distance between the copying roller and
cutter axis.
Accessories, tools
For safety reasons, only use
original Festool accessories and tools!
Festool offers a wide range of accessories for
the routers, e.g. to make wooden joints or
drill rows of holes.
The accessory and tool order number can be
found in the Festool catalogue or on the In-
ternet under www.festool-usa.com.
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro-
vides protection and storage for the tool and
accessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
14.1
14.2
14.3
Place one systainer on top of the other.
Release all four latches on the lower sys-
tainer by pulling back at their top edges
(14.1).
Slide all four latches upward (14.2).
Snap all four latches back to their fl at po-
sition (14.3) so they engage the stacking
tabs of the upper systainer.
Servicing and
maintenance
Any maintenance or repair work
that requires opening of the motor or gear
–
–
–
–
–
–