Festool CT MINI - Manual (Page 4)

4
Use
During the following procedures,
take care not to raise unnecessary dust.
Changing the filter bag
- Open locking clips (1.4), remove top section
(1.5).
- Change filter bag (2.1) – see instructions printed
on filter bag.
- Replace top section, close locking clips.
Note: A replacement filter bag can be stored in
the storage compartment (5.4).
Changing the filter
Do not operate this dust extractor
without a filter, as doing so may damage the
motor.
- Open locking clips (1.4), remove top section
(1.5).
- Fold over handle (3.1) and remove holder (3.2).
- Remove used filter (3.3) and replace with a new
one.
- Replace holder and fold over handle until it
latches into place.
- Replace top section, close locking clips.
Emptying the dirt trap
The dirt trap (2.2) can be emptied after removing
the top section.
Stand
Extending the stand (4.5) keeps the dust
extractor from rolling.
To do this, lift the front end of the dust extractor
slightly and push the stand downwards until it
latches into place.
Press the button (4.4) to release the stand.
Application
The extractor hose (4.2) is connected to the
extractor opening by the angle tube (4.1). During
operation, the extractor hose goes through the
hose opening (4.3).
A Systainer can be attached to the top of the
storage area (5.6) via the four locking clips (5.5).
Note: If this is done, the power cord must run
through opening (5.3).
Vacuuming dry materials
Do not do any dry vacuuming or dust extraction
of dry substances without a filter bag in the tank!
This protects the motor, and lets you dispose of
the evacuated material easily.
The filter becomes damp after evacuating liquids.
A damp filter will suffer accelerated wear if it is
used for dry materials. Accordingly, allow the
filter to dry or replace it with a dry one before
dry operation.
Vacuuming liquids
If foam or liquid escapes, stop
immediately and empty the tank.
The filter bag must be removed before evacuating
liquids. We recommend using a special wet filter
for wet vacuuming.
When the maximum fill level is reached, a level
stop (3.4) will automatically interrupt extraction.