Fostex CD-1A - Manual (Page 3)

3
• If there is a dust, dirt or fingerprints on the
disc, which may cause error in playback or
recording, wipe the disc with a soft, dry cloth
or alcohol from the center out.
Never wipe from the outside to center.
• Do not use a cleaner for analog discs or
antistatic spray, as well as volatile solvents
such as benzine, which may damage the disc
surface.
• Do not expose any disc to direct sunlight, or
leave it in hot, moist or cold places.
• Read the attached manual packed with the
disc before using it.
<Notes on care of disc>
1
<Notes on installing the CD-RW drive>
• The CD-RW drive is made of precision parts.
Do not apply a mechanical shock or use excessive force when installing it.
• Before installing the drive, make sure that the power of the VF-160 is off and the power cord is
disconnected.
• Install the drive correctly according to this manual.
Note that damage to the drive caused by inappropriate installation is not covered by the guarantee.
How to install the CD-1A
Place the VF160 upside down on a material such
as a soft cloth, and unscrew the screw that fixes
the blank panel.
Be careful not to drop the VF160 or give a
strong shock to the VF160, which may dam-
age the hard-disk drive built into it.
Keep the blank panel for future use in case
you unmount the CD-1A.
Keep the screw mentioned above, which
will be used in step 4 below after install-
ing the CD-RW drive.
2 Turn the VF160 over and insert the CD-1A into
the slot on the front panel.
Push the CD-1A firmly, without forcing, so
that the connector of the CD-1A fits into its
companion in the slot.
Blank panel
Unfasten the screw that fixes the blank panel.
Remove the blank
panel.
CD-1A
connector