FMI UNDER HEARTH WOOD NOOK DHS-36 - Manual (Page 3)

www.fmiproducts.com 120114-01C 3
Figure 2 - Panel and Front Face Removal
Figure 3 - Installing Brick into Housing
IMPORTANT: Installation of brick should
be done before wood nook is placed in a
permanent location. Top panel and front face
must be removed prior to installing bricks
(see Figure 2). Bricks are packaged in three
separate boxes. These boxes are labeled by
sections of firebox.
HDS-36
Box # 1 - Left and Right Panel
Box # 2 - Bottom Panel
Box # 5 - Rear Panel
DHS-42
Box # 1 - Left and Right Panel
Box # 3 - Bottom Panel
Box # 6 - Rear Panel
DHS-50
Box # 1 - Left and Right Panel
Box # 4 - Bottom Panel
Box # 7 - Rear Panel
Flanges
Brick
Top Panel
Front Face
Stamped Letter
Location
Brick
Housing
BRICK INSTALLATION
Each brick housing is stamped with a letter (full
size bricks are not stamped). These will help
identify brick when installing. It is important
to install these bricks exactly as instructed.
Install bricks one section at a time starting with
hearth (bottom) panel followed by rear panel
and lastly sides panel (see Figure 3, Figure
4, page 4, or Figure 5, page 5, depending on
your model). It is important to install bricks in
this sequence.
Press Brick firmly into brick housing until it
snaps. Groove line on side of brick will come
in contact with flange on brick housing. This
secures brick into housing (see Figure 3).