Fostex VM04 - Manual (Page 15)

15
VM04 Owner’s manual
Press the CHANNEL EDIT key 1.
PAN dot is flashing. A dot moving up and down.
Indicates L1 ~ L10 or R1 ~ R10.
0
6
12
24
OL
1 2 3 4 L R 1 2 3 4 MIN
L
R
MAX
VIEW
48
EQ
PAN LO HI EFF
SCENE NO.
LEVEL
CH MASTER
VIEW CHANNEL EDIT
MASTER 4 3 2 1
MAX
MIN
MAX
MIN
MAX
MIN
MAX
MIN
0
6
12
24
OL
1 2 3 4 L R 1 2 3 4 MIN
L
R
MAX
VIEW
48
EQ
PAN LO HI EFF
SCENE NO.
LEVEL
CH MASTER
6. Channel Edit Mode
This mode is used to set the PAN, EQ, EFFECT SEND and EFFECT POST/PRE on each input channel.
The CHANNEL EDIT key on each input channel has exactly the same mode of operation. Therefore, we will
discuss their functions using Channel 1 as an example. Press the Channel 1 CHANNEL EDIT Key. The key
itself will light up so that you will be able to confirm you have entered into the CHANNEL EDIT MODE. The
LCD display will show the following message.
Character section
This will display “1-Pan: C”. This
means that you can now adjust the
Channel 1 PAN setting. At this point
the setting will be at the center
position between left and right. This
is related to the VIEW Status
Indicator as its dot is at the PAN
position. You can use the VIEW
key to change the item you want to
adjust; PAN -> EQ Lo -> EQ Hi ->
EFF -> POST/PRE -> PAN.
Press the EXIT key to quit
the CHANNEL EDIT MODE.
You can go back to the
Normal Mix mode.
<Useful info>
The VIEW key works in reverse if
you keep pressing it for a while rather
than hitting it once; PAN -> POST/
PRE -> EFF -> EQ Hi -> EQ Lo ->
PAN.
Channel Fader display
This will numerically indicate the current Channel 1 INPUT Fader position on a
range from 00 to 99. When the indicator is showing 80, the INPUT Fader will be at
the nominal setting.
VIEW display
The two digits at the center of the
bar-graph will start flashing on
Channel 1 from being continuously
lit on the initial setting.
6-1. PAN setting
1. Rotate the DATA ENCODER.
If you turn it clockwise, the character display will
change to R1 -> R10 and the sound will gradually
move to the right. At the same time, the PAN
indication on the VIEW display will change to a
single dot and move upwards (to R).
Similarly, if you turn the dial counter-clockwise,
the display will change to L1 -> L10, the sound will
move to the left and the indicator will move
downwards (to L).
<Useful info>
When turning the DATA ENCODER, the position display
will read L10 ~ C ~ R10 with a 21 step digital indication. And
the actual sound will move smoothly without any clicking or
stepping noise interference.