FujiFilm Pivi MP-300 - Manual (Page 18)

34 35
P
rin
tin
g
Printing
Remove the photo pack.
When the printer runs out of fi lm, the
POWER button goes dark and “0”
appears on the fi lm counter.
x Each time a new image is sent to the
printer, or each time the POWER or
REPRINT button is pressed, the fi lm
counter blinks (5 times) to indicate
that the printer is out of fi lm.
Check that the film counter
shows “0”.
Check for “0”!
When the Film Runs Out
1 1
2 2
1 2
● ● ! Do not take out a photo pack until using up all 10 fi lms.
zThe films will be exposed.
z The film counter is reset when a photo pack is removed and may not
show the correct number of remaining films.
● ● ! Take care not to load a used photo pack.
z Always check the unused check window on the photo pack before
replacing the fi lm.
z If you mistakenly load a used photo pack, the printer will run normally
but will not print images.
Used Unused
On an unused photo
pack, the unused check
window is closed all the
way to the “
■” mark.
On a used photo pack,
the unused check
window is open to the
“
▲” mark.
Check for “0”!
If the printer runs out of fi lm while it is
printing a specifi ed number of images,
the POWER button and the PictBridge
lamp blink rapidly and “0” appears on
the fi lm counter.
Check that the film counter
shows “0”.
x When you replace the fi lm while printing a specifi ed number of prints, leave the
printer turned on. Turning the printer off while replacing the fi lm will delete the
digital camera print settings.
1 1
Load a new photo pack.
(P.22)
x Leave the printer turned on.
Restart printing of the
specified images.
Lit Lit Lit Lit
1 2
3 4
When the POWER button and
PictBridge lamp stays lit, press the
REPRINT button.
2 2
3 3
◆ Notes on reloading photo pack ◆
When the fi lm runs out while printing