Error - error lamp, Date printing position, When pictbridge is used – FujiFilm Pivi MP-300 User Manual

Page 21: Blinking

Advertising
background image

40

41

E

rr

o

r

Error

x The date printed is the date included in the transmitted data.
x If the image has been edited (such as by adding a frame after the picture was

taken), the image’s recorded date may be overwritten.

x Date mode supports EXIF-format data.
x The printed date may be diffi cult to see against some backgrounds. The date

color cannot be changed.

x Date information that was added by a sending device may not be printed

correctly.

If date mode is selected and the image
sent has no date information or has date
information that is not EXIF data, the
ERROR lamp blinks 3 times, the DATE
lamp blinks 7 times at the same time
and the image cannot be printed.
Cancel date mode and then resend the
image or send a different image.

When an image with no date information is sent

Blinking (3 times)

Blinking (7 times)

DATE Mode

Date printing position

2006.06.06

2006.06.06

2006.06.06

2006.06.06

2

0

0

6

.0

6

.0

6

2006.06.06

2

0

0

6

.0

6

.0

6

2006.06.06

When PictBridge is used

Set date mode on the digital camera.

x For information on setting date mode on your digital camera, refer to the

owner’s manual for the camera.

Take the measures described below to restore printer operation.
<Operating temperature too low>
Use the printer at +5°C (+41°F) or higher or warm the
printer at body temperature for around 10 minutes.
<Operating temperature too high>
Use the printer at +40°C (+104°F) or lower or
move the printer to a cool location.

When the ERROR lamp lights

Only use between +5°C and +40°C (+41°F and +104°F).

Operating temperature too high or too low.

ERROR - ERROR lamp -

See “When an image with no date information is
sent”. (P.40)

Date mode error

See “Troubleshooting USB communication
problems”. (P.46)

PictBridge communication error

Lit

(Approx. 7 sec.

→ Power off)

Check image size/format. (P.9, 33)
x If a Progressive JPEG image is sent, the

POWER button may blink.

Case 1. Cannot print transferred data.

Transfer an image.

Case 2. No stored image for “Reprint”.

Blinking

(3 times)

Lit

Lit

Blinking
(3 times)

Blinking
(3 times)

Blinking

(7 times)

Blinking

(7 times)

Blinking
(3 times)

Blinking
(3 times)

Blinking
(3 times)

Blinking
(3 times)

Lit

Lit

Advertising