Furuno GPS NAVIGATOR GP-150 - Manual (Page 57)

8. MENU SETTINGS
8-9
13) Press the NU/CU ENT key. The message
shown in Figure 8-14 appears while data
is being loaded.
Now loading
Waypoint/Route data !
MENU:Stop
Figure 8-14
14) Operate the computer to output data.
When data is loaded, the cursor shifts to
Stop.
15) Press the MENU ESC key. When data is
loaded successfully, The message in
Figure 8-15 appears.
Loading ended successfully
Press any key
Figure 8-15
If data could not be loaded, the message
shown in Figure 8-16 appears.
Failed in loading
Invalid data
Press any key
Figure 8-16
Stopping loading of data
1) Press the MENU ESC key. The message
shown in Figure 8-17 appears.
Are you sure to stop ?
ENT: Yes MENU:No
Figure 8-17
2) To quit loading, press the NU/CU ENT
key. The cursor shifts to Stop.
3) To start loading, select Start.
4) Press the NU/CU ENT key.
Loading waypoint data from YEOMAN
equipment
1) Do steps 1 through 9 in "Loading
lighthouse data."
2) Press or to select WPT.
3) Press t to select Command.
4) Press to select Start. The message
shown in Figure 8-18 appears.
Are you sure to load ?
ENT: Yes MENU:No
Figure 8-18
5) Press the NU/CU ENT key. The message
shown in Figure 8-19 appears.
Now loading
Waypoint data !
MENU:Stop
Figure 8-19
6) Operate the YEOMAN to output data.
When data is loaded, the cursor
automatically shifts to "Stop". Waypoints
are loaded into empty areas. When the
waypoint area becomes full, the message
shown in Figure 8-20 appears.
Waypoint area is full !
Can’t load any data
Press any key to stop
Figure 8-20
7) When the data is loaded, press CU/NU
ENT and MENU ESC. The message
shown in Figure 8-21 appears.
The number of valid and invalid
waypoints appears in the message.