Fender Mustang Mini - Manual (Page 3)

MUSTANG ™ MINI
♫
You can completely change the list of effects available on
your Mustang Mini amplifier as well as access bonus effect
parameters using Fender FUSE software!
The three LEDs next to the EXIT button are numbered to indicate
which effect position (1, 2 or 3) is being selected within each of the
four selection ranges (A, B, C and D). For example, effect selection
"A1" is shown below:
Effects Level
To adjust the level of effects for the current preset, press and hold
the EXIT button while turning the EFFECTS knob:
1 2 3
Tap Button
The TAP button can be used to tap in delay time and modulation
rate settings for the current effect:
• Delay time — TAP button blinks green:
• Modulation rate — TAP button blinks red:
When you select a delay type effect, the TAP button will blink
green in sync with the delay time setting. When you select a
modulation type effect, the TAP button will blink red in sync with
the modulation rate setting.
To set the TAP interval of effects:
1. Select an effect that causes the TAP button to blink, using the
EFFECTS knob.
2. Press the TAP button twice rhythmically in time with the
desired interval.
♫
Press the TAP button just one time to set the delay or
modulation interval to its maximum value.
Guitar Tuner
Your Mustang™ Mini amplifier has a built-in Tuner mode that uses
the control panel LEDs as a chromatic guitar tuner.
To use the tuner:
1. Press and hold the TAP button for 2 seconds. The TAP and EXIT
buttons will illuminate.
2. Strike any single string on your guitar and watch the panel
LEDs. The Preset LEDs are used to indicate the note of the
string being tuned (the top LED "#" also lights up to indicate if
the note is sharp).
1 2 3
3. Turn the tuning peg on your guitar until the fine tuning LEDs
next to the EXIT button indicate that the string is in tune, as
shown above.
4. Standard guitar tuning is as follows:
5. Press EXIT or TAP to exit from the Tuner.
Letters next to LEDs indicate the note being tuned
3 LEDs indicate fine tuning. GREEN means "in tune"
Adjusting the EFFECTS level
3
f e n d e r . c o m