Yamaha NS-PA120 - Manual (Page 4)

3
En
Before you connect the speakers, place each
speaker in its respective location. Speaker
positioning is very important as it affects the
overall sound quality of the system. Place the
speakers in locations that will optimize the
sound quality at your listening position. Refer
to the illustration.
Note
• The speakers feature a magnetically
shielded design. However, there is still a
chance that placing them too close to a
CRT-type TV set might impair picture
color. Should this happen, move the
speakers away from the TV set.
Installing the front speakers
Installing the center speaker
Place the center speaker centrally between the
front speakers, facing directly forward.
When placing it on a flat surface (TV rack,
etc), affix the supplied fasteners to bottom of
the speaker as shown left.
When wall-mounting it, see “Wall-mounting
the speakers” (page 4).
Note
• Wipe the surface clean before affixing the
fasteners. If the surface is dirty, oily or wet,
adhesive strength is weakened and the
speaker may fall.
Installing the speakers
Center
Front
right
Surround left
Front
left
Surround right
Base
Screw
Philips driver
Adaptor
Bottom of the
front speaker
■ Attaching the speaker stands
Lay the front speaker (with the front side up)
on the floor and then attach the adaptor and
base to the speaker by using the supplied
screws.
Notes
• When moving the front speaker, be sure to
have another person to support it.
• When laying the front speaker, use a blanket
or cushion to avoid scratches on the floor.
• Tighten the screws firmly so that the front
speaker never gets shaky.
Place the two front speakers on the left and
right sides of the TV, facing directly forward.
Fastener
Peel of the seal.
TV rack, etc