FUJITSU PRIMERGY BX600 S2 - Manual (Page 28)

28 PRIMERGY BX600 S2 Basic Unit
Notes on Installing in the Rack Important Notes
©
c
o
g n it
as
. Ge
s e
lls
c h ft
f ü r T
e c
h n ik
-Do
k u
m
e nt
at
io
n m
b H
2
007
P
fad:
H:
\w
in
dows
\_p
roj
e k te\
B
x z \B
e tr
ie
b
s a n le
it un
g\
V e
rs
ion_
M
a e
rz
-2
007
\A
rc
h iv
\B
X
6
0 0 S
2
_ en\
bl
ad
e-u
s .k
0 3
3.6 Notes on Installing in the Rack
V
CAUTION!
● For safety reasons, at least two people are needed to install the
basic unit because of its weight and size.
● For lifting the basic unit, use the handles on the front and the fold-out
handles on the long sides of the chassis.
● Before lifting the basic unit into the rack, remove server blades, fan
units and power supplies from the system unit to reduce weight.
● For lifting the basic unit, use the handles on the front and the fold-out
handles on the long sides of the chassis.
● Never lift or transport the server using the handles on the rear.
● For safety reasons only one unit may be withdrawn from the rack at a
time when performing assembly or service work.
● Ensure that the anti-tilt bracket is correctly mounted when you set up
the rack.
● If more than one unit is withdrawn from the rack at any one time, the
rack is in danger of tilting forward.
● When connecting and disconnecting cables, read the relevant notes
in the “Important notes” chapter in the technical manual for the
relevant rack. The technical manual is supplied with the corre-
sponding rack.
● The power connection for the rack must be installed by an authorized
technician (electrician).
● If the server is integrated in a (rack) installation that receives power
from an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type-A connector.
● The power supply for the rack should be divided amongst the three
phases of a three-phase power connection.