Friedrich CP05N10A - Manual (Page 4)

—3—
1.3 LOCATIONS OF CONTROLS
MONEY SAVER 2
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and sample the room air to determine if
more cooling is needed.
TEMPERATURE SETTING 1
• These buttons control the temperature of the room.
The temperature can be set within a range of 60
°
F to 86
°
F, in increments of 1
°
F.
ON/OFF TIMER
4
ON–When the air conditioner is off, it can be set to automatically
come on in 1 to 12 hours from its previous setting. Each touch will increase the timer by 1
hour.
OFF–When the air conditioner is on, it can be set to automatically
turn off in 1 to 12 hours. Each touch will increase the timer by 1 hour. After the timer has been
on for 30 minutes, the temperature will automatically rise 2
°
F, and after another 30 minutes, it
will automatically rise 2
°
F again. The temperature will then stay the same until the timer goes
OFF.
To cancel the timer, press the TIMER pad until the display time disappears.
POWER 5
• To turn the unit ON, push the button. To turn the unit OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the unit is on the High cool mode and the temp. at 72
°
F
FAN SPEED 6
• Everytime you push this button it will rotate between the following fan speeds:
High (F3)
→ Low(F1) → Medium (F2) → High (F3)
OPERATION MODE SELECTOR 3
• Everytime you push this button, it will rotate between the COOL, FAN and DRY modes.