Fisher LO540 - Manual (Page 3)

3
2
• First lift the front rails and then push out the back rails.
Assembly
• Place the side rails on a flat surface.
• Fit the crossbar tabs into the small rectangular opening in each side
rail. Push the crossbar down completely.
• Insert two #4 x 20 mm screws into the crossbar and tighten.
• Insert and "snap" the back rails into the sockets in the side rails.
Pull up on the back rails to be sure they are secure.
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel
for replacement parts and instructions if needed. Never
substitute parts.
1
Side Rails
Crossbar
LIFT
3
PUSH
LIFT
PUSH
4
Side Rails
Front Bar
Hint: You may want to install batteries into the soother before
assembling the front bar to the front rails.
• Position the front bar so that the soother is upright. Fit it to grooved
area on the inside of the front rails.
• Insert four #4 x 20 mm screws into the front rails and tighten.
Hint: You may need the help of another adult to hold the front
bar in place while you insert and fasten the screws.