Fujitsu Siemens Computers Bump Case FPCCC24 - Manual (Page 3)

3
Installing the Tablet PC
Figure 2. Bump case - Rear
To install your Tablet PC into the bump case, position the
case face down as shown in Figure 2. Open the right side flap
of the case (as seen from the back). The flap is secured by a
long strip of Velcro® that is attached to the back of the bump
Prior to installing the Tablet PC into the bump
case, remove the pen. Once the system is
installed, you won’t be able to remove the pen.
Store the pen in the pen holder. (See Fig. 1)
Side Flap Pen holder Side Flap
Velcro
Strips Hand
straps D-Rings
(4 places)
Battery
Release
Latch access
FPC58-0721-03.fm Page 3 Thursday, January 22, 2004 2:01 PM