Fantom Vacuum FS801 - Manual (Page 4)

OPERATING INSTRUCTIONS PRECAUTIONARY MEASURES
Wash
once a
month or
when
suction
appears
reduced
Fig. A
Changing & Cleaning the Post
Motor Filter
The post motor filter is a washable filter
but should be replaced every three (3)
months.
• Remove the filter cover from the front
of the unit and remove the filter.
• Rinse the post
motor filter in
lukewarm water
and air dry the
filter completely
for 24 hours. Do
not use a washing
machine to rinse
the filter. Do not
use a hair dryer to
dry it. Air dry only.
Never operate the
vacuum without the
post motor filter in place.
• When the filter is dry, replace into the
filter cover and replace the filter cover
to the unit.
• A severely soiled or clogged filter
should be thoroughly washed with
fresh tepid water. A mild detergent
can be used if required.
CAUTION : The suction hole must
be open, free of any obstructions at
all times. Otherwise, the motor will
overheat and could become
damaged.
PLEASE NOTE: The white pleated
filter material in the HEPA Filter will
discolor over time -This is NORMAL
and will NOT affect the performance
of the filter. If the HEPA Filter
is properly
"TapCleaned”
after each use
and suction
does not return
to 100%, then
we suggest that
the HEPA filter
be “TapCleaned”
vigorously until
no more dust
can be removed,
then rinsed
under the faucet and allowed to air dry
for 24 hours before refitting into the
vacuum. (Fig. A) This should be
done once a month or when
suction appears to be reduced .
Warning: Allow 24
hours for drying before
replacing in unit.
Warning: Always empty the dust
cup container and clean the HEPA
filter, Non-Woven Pre-Filter and
Debris Screen before each use
and during prolonged usage.
Changing & Cleaning the Pre-
Motor Filter
The pre-motor filter is a washable filter
but should be replaced every three (3)
months.
• Remove the dust cup container, the
non-woven pre-filter and the HEPA
filter to remove the pre-motor filter.
• Rinse the pre-motor filter in lukewarm
water and air dry the filter completely
for 24 hours. Do not use a washing
machine to rinse the filter. Do not use
a hair dryer to dry it. Air dry only.
Never operate the vacuum without the
pre-motor filter in place.
• When the filter is dry, replace into the
unit and replace the HEPA filter and
dust cup container.
• A severely soiled or clogged filter
should be thoroughly washed with
fresh tepid water. A mild detergent
can be used if required.
Please Note: The HEPA Filter is
washable. It should, however, be
replaced every three (3) to six (6) months
to ensure peak performance of your
vacuum.
The non-woven pre-filter, pre-motor and
post motor filters are washable. They
should however be replaced every three
(3) months to ensure peak performance
of your vacuum.
Important: Make sure that ALL filters are
completely dry before re-installing back in
the vacuum.
8
Pre-Motor
Filter
Never over fill the dust cup container -
remove dirt and clean the HEPA filter,
non-woven pre-filter and debris screen
when dirt in dust cup is at or below the
"MAX" level during prolonged usage or
risk motor damage.
If you wash the Hepa filter or the non-
woven pre-filter, make sure that it is
completely dry before inserting back
in the vacuum.
IMPORTANT: If the suction opening in the unit or the hose is BLOCKED, switch off
the vacuum cleaner and remove the blocking substance before you
start the unit again.
1. Do not operate the vacuum cleaner
too close to heaters, radiators or
cigarette butts.
4. When pulling out the power plug
from the wall outlet, pull the plug not
the power cord.
5. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
2. Before inserting the power plug into
the wall outlet, make sure that your
hands are dry.
6. Do not use without HEPA filter in
place.
3. Before you start vacuuming, make
sure to remove large or sharp objects
that might damage the dust cup
debris screen.
3