Festool MFK 700 - Manual (Page 11)

11
Attach a different clamping collet with lock- –
ing nut to the spindle.
Screw on the locking nut loosely. Do not
–
tighten the locking nut until a router bit is
inserted.
Adjusting the routing depth
8-2
8-3
8-1
1
1
3
3
2
8-3 8-2
1
3
2
Unscrew the rotary knob [8-3] and the –
clamp [8-1] (“large surface router table”
only).
Turn the rotary wheel [8-2] to set the router
–
table to the required routing depth.
Tighten the rotary knob [8-3] and the clamp
–
[8-1] (“large surface router table” only).
Dust extraction
Breathing in dust can dam-
age the respiratory passage! Always con-
nect the machine to a dust extractor. When
performing work that generates dust, always
wear a dust mask.
Extraction hoods are supplied for both router
tables; a Festool extractor (extractor hose
with a diameter of 27 mm) can be connected
to these extraction hoods.
The dust extractor (extractor hose with dia.
27 mm) can also be attached to the “large
surface router table” or the side stop depend-
ing on the application.
Working with
the machine
Always hold the machine
with both hands during working.
Always secure the workpiece
in such a manner that it cannot move
while being routed.
Guide the machine along the workpiece at f
a steady rate of advance.
Machine guidance methods
a) Routing with side stop
The side stop is positioned parallel to the
workpiece edge.
The side stop can only be fi tted to the “large
surface router table” without a fi tted extrac-
tion hood.
9-4 9-3
9-5
9-2
9-1
Insert the fi ne adjuster [9-3] into the side –
stop.
Secure both guide rods [9-5] with the two
–
rotary knobs [9-2] on the side stop.
Insert the side stop into the grooves on the
–
router table to the required distance and
secure the guide rods by turning the rotary
knob [9-1].
Rough adjustment
Loosen the screws [9-2] and [9-4] and slide –
the side stop.
Tighten the screws.
–
Fine adjustment
Loosen the screws [9-2] and turn the green –
wheel on the fi ne adjuster [9-3].
The distance between each line on the ro-
f
tary wheel is 0.1 mm - one full turn of the
ring represents 1 mm.
Tighten the screws [9-2].
–