FUJITSU TE988G - Manual (Page 16)

Fujitsu TE988G Color Monitor
15
Trouble Shooting
If you are experiencing difficulties with your monitor, check following table for possible
solutions.
Problem Items to check
? No picture 1. The VGA card should be completely seated in the slot.
2. Power switch of the monitor and the PC should be in the ON
position.
3. The signal cable should be completely connected to the video
card / computer.
4. Check if the pins of the connector are twisted or shrunk.
? Image is scrolling or
unstable
1. The signal cable should be completely connected to the
computer.
2. Check the pin assignments and signal timings of the monitor
and your video card.
? LED on the monitor is
not lit
1. Power switch should be in the ON position and the power cord
should be connected.
2. Check if the system is in the power saving mode. ( Check by
pressing any one of keys on the keyboard or moving the
mouse.)
? Picture is fuzzy 1. Adjust the Contrast and Brightness Controls.
? Picture bounces or wave
pattern is present in the
picture
1.. Move electrical devices that may be causing electrical
interference away from the monitor.
2. Refer to the FCC information of this manual.
? Edges of the display
image are cured either
inward or outward
1. Adjust the geometry control to adjust the display image.
2. Locate the monitor facing to east.
? Display image is not
centered, too small, or
too large
1. Adjust the image using Size and Position Controls in the OSD.