Fisher SC-TA3000 - Manual (Page 10)

10
TROUBLESHOOTING
Before inquiring about service and maintenance, please check the following points listed
below.
Power won’t turn on even
when the on/off pedal
switch is turned on.
Is the power cord plug
firmly plugged into the
outlet? Insert power cord plug
firmly into the outlet.
(See page 5)
Suction power
has weakened.
Is the hose firmly attached
to the main unit?
Has dirt clogged up the
hose?
Did you check the "Max" fill
line to see if the dust
container is full?
Is dust and debris
clogging the filter? Make sure the hose is
attached. (See page 7)
Remove the clogged dirt.
Empty the dust container.
(See page 8)
Clean the filter.
(See pages 8-9)
The rotating brushes
won’t turn.
Did you press the handle
release pedal?
Has dirt clogged up the
rotating brushes?
If the rotating brushes still won't turn after checking the
above points and possible solutions, an internal drive
belt in the floor nozzle may be broken. Contact an
authorized service center for further evaluation.
(See page11)
Press the handle release
pedal and pull back on the
handle. (See page 6)
Remove the clogged dirt.
(See page 9)
Dirt and debris are flying
out from the exhaust vent.
Have the filter and dust
container been correctly
attached?
POWER SUPPLY AC120V 60Hz
POWER CONSUMPTION 10 Amps
CAPACITY OF DUST CONTAINER 0.8 Gallon
DIMENSIONS (W x D x H) 13-3/8” x 15-3/4” x 43-11/16”
WEIGHT 14.3 lbs
POWER CORD LENGTH 25 ft
ACCESSORIES
Floor nozzle (1), Crevice Tool (1), Handle (1),
Brush (1), Wand (1)
Make sure they are
attached correctly.
(See page 8-9)
TROUBLE CHECK POINT POSSIBLE SOLUTION
SPECIFICATIONS