Fisher & Paykel 525911L - Manual (Page 28)

27
To Clean the Filter Plate
· Ensure the DishDrawer is cool before you start
cleaning.
· Follow the above instructions for removing the
drain filter and spray arm.
· In the center of the filter plate, there are two rings.
Hold the center ring still and turn the outer ring
counter clockwise, about a 1 /
8
turn. This will release
the filter plate.
· When cleaning the underside of the filter plate, care
must be taken on the sharp outer edge to avoid the
risk of cut type injuries.
· Remove any soil, wash in hot soapy water and
rinse thoroughly in clean water. The heater plate
can be wiped with a damp cloth.
· Replace the filter plate so it lies flat in the base of
the DishDrawer ensuring the filter plate is fully
locked into position with the outer ring. To lock
the filter plate into position, ensure the triangles
(s) align with each other (see Figure 25 for the
correct position). The filter plate must not be
able to move about freely.
To Clean the Motor Assembly
This area only needs to be cleaned when a "U3" or
"F2" fault code appears on the Electronic Display.
· Follow the above instructions for the removal of the
drain filter, spray arm and filter plate.
· Turn the rotor-locking ring anticlockwise and lift out.
Once the motor assembly is lifted up, check the
cavity for any foreign matter like bones or seeds
and remove.
· Replace the motor assembly back into the small
cavity in the DishDrawer. Turn the motor assembly
clockwise about 1 /
8
of a turn to lock into position.
The arrows ( ) on the rotor locking ring and motor
housing must align with each other (See Figure 26).
Figure 26 -
Motor Assembly
Key
1. Impeller
2. Rotor Locking Ring
3. Heater Plate
Note: The DishDrawer must be used with the motor assembly, filter plate, drain filter
and spray arm correctly in place.
Figure 25 -
Correct Locking Position
of Filter Plate with Motor
Assembly
Vacation Time
If the DishDrawer is not going to be used for some time, we recommend you:
· Ensure the baskets are empty.
· Leave the inside of the DishDrawer clean.
· Leave the drawers ajar to allow air to circulate.
· Turn off both the electricity and water supply to the DishDrawer.
1.
2.
3.