Ferrari stereo - Manual (Page 9)

9
General Operation
Loudness on /off
Press button and then multifunction button “LD”. LOUD ON or LOUD
OFF are displayed. The loudness can be switched on or off alternately by
pressing the multifunction button.
Linear adjustment
Activate tone menu. Then again press and hold button for more than 2
seconds. The tone values for the set signal source (e.g. radio/FM) are set to an
average value FM LINEAR.
Press and hold
button for more than 4 seconds. All tone values for the
signal sources radio and tape / CD are set to an average value ALL LINEAR.
Adjust mono / stereo
Three different reception optimisation settings can be set in order to suppress
reception dependent interference and reflections.
Repeatedly press multifunction button “ST” in tone menu until the desired
optimisation is set.
AUTO: Setting for normal operation - i.e., the unit switches from stereo to
mono and back depending upon reception location (provides the optimum
setting for almost all reception areas).
STEREO: Setting for unusal reception situations - i.e. the unit is set
permanently to stereo (e.g. for private radio stations in city areas)
MONO: Setting for reception conditions in which reflections constantly occur
- i.e., the unit is set constantly to mono.
The setting is effective immediately after pressing the multifunction button
“ST” and is also retained on switching off.
!
USEnglisch.bk : Allgemeine.fm Seite 9 Freitag, Februar 1, 2002 10:33 AM