Fisher PDG-DWT50L - Manual (Page 19)

1. Introduction
10
I TEM L ABEL D ESCRIPTION S EE P AGE :
10.
SCREEN
TRIGGER
When connected to the screen through a commercially available
cable, the screen deploys automatically on start up of the projec-
tor. The screen retracts when the projector is powered off
(see notes below)
117
11. S-VIDEO
Connect a commercially available S-video cable from a video
device
30
12. POWER SWITCH Turn on/off the projector
32,41
13. AC IN Connect the supplied power cable 31
14.
AUDIO IN
[L(MONO)/R]
(VIDEO) Connect RCA audio cables (not supplied) from the input device
right and left channels. This audio jack is shared with S-Video
input.
—
15. VIDEO IN
Connect a composite video cable (not supplied) from a video de-
vice to the yellow RCA jack
30
16.
COMPONENT IN
(Y, Cb/Pb, Cr/Pr)
Connect a component video enabled device 29
17.
COMPUTER 2 IN
(R/Cr, G/Y, B/Cb,
H, V)
Connect RGBHV or Component signal from computer or com-
ponent video enabled device
26
18. COMPUTER 1 IN Connect a VGA cable (supplied) from a computer
19.
AUDIO IN
(COMPUTER 1)
Connect the audio cable (not supplied) from the input device
—
20. LAN Connect a LAN cable (not supplied) from a computer
26
21. SERVICE
Connect the USB cable (not supplied) from a computer. For ser-
vice personnel only.
—
Note:
To use this feature, you must turn on the Screen Trigger function on the OSD.
Screen controllers are supplied and supported by screen manufacturers.
Do not use this jack for anything other than intended use. Connecting the wired remote control to the
Trigger mini jack causes damage to the remote control.