Fisher PDG-DWT50L - Manual (Page 43)

3. Projecting an Image (Basic Operation)
34
Selecting an Input Source
The Input Source can be selected from the projector's control panel or from the remote control unit. Refer to the following
guide to select the Input Source.
1.
Press Menu on the OSD control panel or on the remote
control unit to display the Main Menu. Scroll to the
Input menu using ▲or▼ and press Select.
Note:
Return to the projected image by pressing Cancel
twice.
2.
Select the required source using ▲or▼ and press
Select.
Note:
If an XGA signal is not correctly recognized, set “WXGA Mode” to off (see page
63 ).
To check if the signal is recognized, go to “Input” under “Information” menu (see page 90 ).