Fitness Quest 7.0r - Manual (Page 9)

handlebar
tube
water bottle
holder
remove and
re-insert screw
remove and
re-insert screw
front of unit
main frame
assembly
front
handlebar
STEP 7 – Computer Assembly
a) Remove the four Phillips Bolts
from the back of the Computer.
b) Snap together Connectors for
Computer, tucking the Wires
inside the Handlebar Tube.
Be careful not to pinch wires.
The Book Holder can be attached
to the Computer at any time.
c) Attach the Computer using the
four Bolts removed in (a).
Tighten with the Screwdriver
provided.
d) Remove Battery Door on the back of the Computer.
Insert four “C” Batteries (included) in numbered order
and replace Battery Door.
8
front of
unit
9
STEP 9 –
AC Adapter
Insert AC Adapter
into front of unit,
then plug into wall.
STEP 8 –
Water Bottle
Holder
Remove Phillips Screws
from Handlebar Tube.
Line up Water Bottle
Holder and attach to
the Handlebar Tube by
re-inserting Phillips Screws
and tightening them
with the Screwdriver
provided.
book holder
connectors
handlebar
tube
computer
Front
View
4
1
3
2
four "C" batteries
back of
computer
handlebar
tube
battery
door
Back View
7c
7d
7b
Assembly is now complete.
IMPORTANT:
Please read pages 9-10 before beginning
your workout for important instructions
on how to use your New Balance
7.0r Recumbent Bike.
8
handlebar
tube
front of unit
main frame
assembly
front
handlebar
allen bolts,
washers, nuts
and nut caps
bolt and
washer
looking from
the right side
handlebar
tube
front
handlebar
allen bolts,
washers, nuts
and nut caps
bolt and
washer
STEP 6 – Front Handlebar Assembly
Remove the Allen Bolts, Washers and Nuts
with Nut Caps from the Front Handlebar and
the Bolt and Washer from the Handlebar
Tube. Position the Front Handlebar in place
on the Handlebar Tube with the bolt hole at
the bottom. Replace the Bolts, Washers, Nuts
and Nut Caps you just removed and tighten
with the Wrench provided.