FUNAI TB110MW9 - Manual (Page 18)

18
EN
Advanced Operation Operation
Autoscan
(Receiving Channels)
Autoscan receives available digital channels and
stores them in a channel map.
CAUTION:
•
If autoscan is skipped, digital channels may not
be received correctly.
1 Press [SETUP].
2 Select “CHANNEL” using [
K / L ],
then press [OK].
3 Select “AUTOSCAN” using [
K / L ],
then press [OK].
CHANNEL
EXIT
CHANNEL
TIME
DETAIL
INITIAL
ADD/DELETE
ANTENNA
AUTOSCAN
RF OUT
4 Select “AUTOSCAN” using [
K / L ],
then press [OK].
AUTOSCAN
EXIT
CHANNEL
TIME
DETAIL
INITIAL
AUTOSCAN will rescan all channels.
This may take a while to complete.
BACK
AUTOSCAN
AUTOSCAN
The system is now scanning.
12% Channel Found
EXIT
•
STB starts receiving available digital
channels and stores them in the channel
nel
map.
•
When the scan nning is complete,
“AUTOSCAN CO OMPLETED” will be indicated.
•
After autoscan is complete, use [CH K / L ]
to verify whethe er STB is receiving channels
properly.
To cancel during scanning:
Press [SETUP] or [OK].
NOTE:
•
If canceled, some channels not yet scanned may
not be received. We recommend completing
autoscan.
•
When you want to completely refresh the
channel map, delete all the channels, then do
the autoscan again. See “Adding/Deleting
Channels” on this page for details.
When “NO SIGNAL” appears on the TV screen:
Verify the antenna connection, then scan again.
The STB tunes in channel 2-1 and “NO SIGNAL”
appears if the STB could not receive any channels.
Adding/Deleting Channels
Add or delete desired channels in the channel map.
CAUTION:
•
You cannot recover the deleted channels once
they are deleted unless you perform the
autoscan again.
1 Press [SETUP].
2 Select “CHANNEL” using [
K / L ],
then press [OK].
SETUP
EXIT
CHANNEL
TIME
DETAIL
INITIAL
ADD/DELETE
ANTENNA
AUTOSCAN
RF OUT
3 Select “ADD/ DELETE” using [
K / L ],
then press [OK].
CHANNEL
EXIT
CHANNEL
TIME
DETAIL
INITIAL
ADD/DELETE
ANTENNA
AUTOSCAN
RF OUT