FUJITSU LIFEBOOK C2111 - Manual (Page 79)

73
T r o u b l e s h o o t i n g
The Media Player Access
indicator on the Status
Indicator Panel blinks at
regular intervals when
no disc is in the tray or
the media drive is not
installed. The Windows media player auto
insert notification function is
active and is checking to see if a
media disc is ready to run. This is normal. However, you may disable this
feature. (See Auto Insert Notification Function on
page 41 for more information)
The media player will
not play international
DVD titles The region code for the DVD
does not match that of the media
player. All Fujitsu notebook DVD players are set to play
DVD titles with region code number 1, which is
specified for the North American market. The
region number is a regional restriction code defined
by the DVD Forum acting on the requirements of
Hollywood. Different region codes are recorded on
video DVD titles for publication in different areas of
the world. If the regional code of the DVD player
does not match the regional codes on the titles, then
playback is impossible.
NOTE: You can change the region code on the DVD
player using the Properties menu of the DVD soft-
ware. Note, however, that you can only change the
region code up to four times. After the fourth
change, the last region code entered becomes
permanent, and cannot be changed.
The LifeBook notebook
fails to Auto-Play a DVD
movie. The media player software has
not been installed. Locate and install the DVD-ROM Applications CD.
Floppy Disk Drive Problems
You cannot access your
floppy disk. You tried to write to a write
protected floppy disk. Eject the floppy disk and set it to write enable. (See
Internal Floppy Disk Drive on page 37 for more infor-
mation)
Floppy disk is not loaded
correctly. Eject floppy disk, check orientation and re-insert.
(See Internal Floppy Disk Drive on page 37 for more
information)
BIOS setup utility states Floppy
Disk Controller:
Disabled.
Revise the setup utility Main menu settings to
enable Diskette Controller. (See BIOS Setup Utility
on page 27 for more information)
Security is set to protect access to
floppy disk data. Verify your password and security settings.
Hard Drive Problems
You cannot access your
hard drive. The setup utility is incorrectly set
for your internal (Primary
Master) or optional second hard
drive (Primary Slave). Revise BIOS settings to set both Primary Master
and Primary Slave correctly. (See BIOS Setup Utility
on page 27 for more information)
The wrong drive designator was
used by an application when a
bootable CD-ROM was used to
start the LifeBook notebook. Verify drive designator used by application is in
use by the operating system. When the operating
system is booted from a CD, drive designations
are automatically adjusted.
Problem Possible Cause Possible Solutions
B5FH-5971.book Page 73 Thursday, May 23, 2002 4:13 PM