FUJITSU LIFEBOOK C2111 - Manual (Page 83)

77
T r o u b l e s h o o t i n g
The batteries seem to
discharge too quickly.
(continued) The power savings features may
be disabled. Check the power management and/or setup utility
settings in the Power Savings menu and adjust
according to your operating needs.
The brightness is turned all
the way up. Turn down the brightness adjustment. The higher
the brightness the more power your display uses.
The batteries are very old. Replace the batteries.
The batteries have been exposed
to high temperatures. Replace the batteries.
The batteries are too hot or too
cold. Restore the LifeBook to normal operating tempera-
ture. The Charging icon on the indicator panel will
flash when the battery is outside operating range.
Shutdown and Startup Problems
The Suspend/Resume
button does not work. The Suspend/Resume button is
disabled from the Advanced
submenu of the Power menu of
the setup utility. Enable the button from the setup utility.
You did not hold the button in
long enough. Hold the button longer. This may need to be a few
seconds if your application is preventing the CPU
from checking for button pushes.
There may be a conflict with the
application software. Close all applications and try the button again.
The system powers up,
and displays power on
information, but fails to
load the operating
system. The boot sequence settings of the
setup utility are not compatible
with your configuration. Set the operating source by pressing the [ESC] key
while the Fujitsu logo is on screen or use the [F2]
key and enter the setup utility and adjust the source
settings from the Boot menu. (See BIOS Setup
Utility on page 27 for more information)
You have a secured system
requiring a password to load your
operating system. Make sure you have the right password. Enter the
setup utility and verify the Security settings and
modify them as accordingly. (See BIOS Setup Utility
on page 27 for more information)
Internal hard drive was not
detected. Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try to
auto detect the internal hard drive.
An error message is
displayed during the
LifeBook notebook
(boot) sequence. Power On Self Test (POST) has
detected a problem. See Power On Self Test (POST) messages to deter-
mine the meaning of the problem. Not all messages
are errors; some are status indicators. (See Power On
Self Test Messages on page 80 for more information)
Your LifeBook note-
book appears to change
setup parameters when
you start it. BIOS setup changes were not
saved when you made them and
exited the BIOS setup utility
returning it to previous settings. Make sure you select Save Changes And Exit when
exiting the BIOS setup utility.
The BIOS CMOS hold-up battery
has failed. Contact your support representative for repairs.
This is not a user serviceable part but has a normal
life of 3 to 5 years.
Problem Possible Cause Possible Solutions
B5FH-5971.book Page 77 Thursday, May 23, 2002 4:13 PM