Fostex VF-16 - Manual (Page 5)

<About save error>
If an error occurs for some reason during the
save operation, the error message as below
appears.
If it appears, press the [ EXIT/NO ] key.
The display returns to the previous screen
before performing the save operation.
Note that saved data before the error message
appears is all invalid.
<Note for saving data to more than one disc>
If you save data to more than one disc, we recom-
mend to put a number on each disc in the saving
order (such as
DISC-1 , DISC-2 , etc.) so that you will
easily know the order for inserting discs when load-
ing data.
<Hint 1>
In the description for saving data above, we
assume to use a non-recorded CD-RW disc.
If you use a recorded disc (including a disc
on which computer data is recorded), also
note the following.
By performing step 4 in the save operation
procedure shown above ("While "
SCSI " is
flashing, press the [ ENTER/YES ] key.") when
a recorded disc is inserted, the display shows
a warning message, followed by the confir-
mation screen (where "
Sure? " flashes).
With this screen, you can choose whether eras-
ing the recorded data or ejecting the disc.
• To erase the existing (recorded) data
Press the [ ENTER/YES ] key while both " ERASE " and
" Sure? " are flashing.
The display shows the screen below and the VF-
16 starts erasing the disc.
As the erase process progresses, the number of
flashing "
* " increases from left to right.
• To eject the disk
Use the [ JOG ] dial to highlight " Eject " (flashing)
and press the [ ENTER/YES ] key.
The disc is ejected while the display shows " Insert
Disk! ."
By inserting a disc, you can start the save opera-
tion again from the beginning.
Immediately after completing erasing the disc, the
display shows the same screen (for selecting a pro-
gram to be saved) which appears after step 4 is
performed. Hereafter, perform the same proce-
dure as described above.
<Note>
You cannot abort the save operation before com-
pleted. Especially during the save operation to more
than one disc, if you happen to press the [
EXIT/NO ]
key while removing or inserting a disc, you have to
redo the save operation from the beginning with
the first disc.
Flashing
Increases as the process progresses.
<Note>
If the message above appears while saving data
to a CD-R disc, you can no longer use the disc.
Flashing
Flashing
Flashing
5