Fostex VF-16 - Manual (Page 6)

2. Press the [SETUP] key to enter the setup mode.
The display shows the screen for selecting the setup menu.
In the following procedure, we assume that a CD-
RW drive is connected to the VF-16 SCSI port
and a CD-RW disc to which data has been saved
is prepared.
4. While "SCSI" is flashing, press the [ENTER/YES] key.
After showing the model name of the CD-RW drive, the
display shows the backup number and title, as well as
recorded space.
3. Use the [JOG] dial to select (highlight) "Load PGM" and
press the [ENTER/YES] key.
The display shows the screen for selecting a load device,
where "
SCSI " is flashing.
By rotating the [ JOG ] dial, you can select a desired
program number/title from among available programs
in the VF-16 current drive. You can also select "
Eject ."
If you select " Eject " and press the [ ENTER/YES ] key, the
disc is ejected.
Loading data from a CD-RW drive
<Note>
Do not carry out any VF-16 key operation until the ac-
cess process to the CD-RW disc is completed.
<Note>
If you load song data which is saved to more than one
disc, set DISC-1 first.
If you set the other disc and go on the following pro-
cedure, the VF-16 automatically recognized that the
disc order is not correct and the display shows "
Wrong
Disk ", followed by " Illegal No! " momentarily, and the
disc is automatically ejected.
1. After turning on both the VF-16 and the CD-RW drive
connected, insert the disc to the CD-RW drive.
<Hint 2>
If you try to save data to a recorded CD-R disc, the
display shows a warning message saying "
Not Writ-
able! ", followed by a message saying " Insert Disk " as
below.
Flashing
Flashing
6