Fitness Quest 9.5e - Manual (Page 9)

STEP 6 – Computer Assembly
a) Remove the four Phillips Screws
from the back of the Computer.
b) Snap together Connectors for
Computer, tucking the Wires inside
the Vertical Column. Be careful
not to pinch wires.
The Book Holder can be attached
to the Computer at any time.
c) Attach the Computer using the
four Screws removed in (a).
Tighten with the Screwdriver
provided.
d) Remove Battery Door on the back of the Computer.
Insert four “C” Batteries (included) in numbered order
and replace Battery Door.
8
main
frame
assembly
8
STEP 8 –
AC Adapter
Insert AC Adapter
into front of unit,
then plug into wall.
STEP 7 –
Water Bottle
Holder Assembly
a) Remove Phillips
Screws from Vertical
Column. Line up
Water Bottle Holder
and attach to the
Vertical Column by
re-inserting Phillips
Screws and tightening
them with the
Screwdriver provided.
b) At this time connect
the Pulse Wires on
both sides of the
Vertical Column.
book holder
connectors
vertical
column
computer
Front
View
left
swing arm
vertical
column stationary
handlebar
bolt
hole
STEP 5 – Stationary Handlebar
Assembly
Remove the Allen Bolts, Washers and Nuts
with Caps from the Stationary Handlebar
and the Bolt and Washer from the Vertical
Column. Position the Stationary Handlebar
in place on the Vertical Column with the
bolt hole at the bottom. Replace the Bolts,
Washers, Nuts and Caps you just removed
and tighten with the Wrench provided.
looking from left side
ng from looking from
eft side the left side
he unit of the unit
looking from the
left side of the unit
vertical
column
pulse
wires
pulse
wires
water bottle
holder
remove and
re-insert
phillips screw
remove and
re-insert
phillips screw
7a
4
1
3
2
four "C" batteries
back of
computer
vertical column
battery
door
Back
View
5
6c
6d
6b
Assembly is now complete.
IMPORTANT:
Please read pages 9-10 before beginning
your workout for important instructions
on how to use your New Balance
9.5e Elliptical Trainer.
7b
heart rate
receiver