Friedrich CP08 - Manual (Page 15)

13
Sash track
Front Angle
About
1
/ 2
"
Screw(Type B) 6
Screw(Type B) 6
Sill Support 2
Sill Support 2
Foam-Strip 8
Fig. 5
Type C 7
Fig. 6
Screw(Type A)
Screw
(Type A)
Power cord Fig. 7
Fig. 8
6. The cabinet should be installed with a very slight
tilt (about 1/2") downward toward the outside
(See Fig. 5).
Adjust the bolt and the nut of Sill Support
for
balancing the cabinet.
7. Attach the cabinet to the window stool by driving
the screws [Type B: Length 16mm (5/8 inch)
and below.] through the front angle into window
stool.
8. Pull each Frame Curtain to each window
sash track, and repeat step 2.
9. Attach each Frame Curtain to the window
sash using screws (Type C). (See Fig. 6)
CAUTION: Do not drill a hole in the bottom pan.
The unit is designed to operate with
approximately 1/2" of water in bottom
of pan.
There is no need to add water if the
pan is dry.
10. Slide the unit into the cabinet. (See Fig. 7)
CAUTION: For security purpose, reinstall the 2
screws (Type A) at cabinet's side, that
were removed in step 1 on page 10.
11. Cut the Foam-Strip to the proper length
(window width) and insert between the upper
window sash and the lower window sash.
(See Fig. 8)
ENGLISH
15