FUJITSU CG-301 - Manual (Page 8)

LENS
This camera can accommodate DC voltage drive auto-iris lens. VIDEO signal controlled lens is not available.
ELECTRONIC CONNECTIONS
Table.1 shows wiring scheme for the 4pin Auto iris connector.
Lens Connector Auto-iris Lens
2 1
4 3
(View from wiring side of plug)
Fig. 2
Table 1
DC VOLTAGE DRIVE
AUTO-IRIS LENS
1
2
3
4
CONT. ( )
CONT. (+)
DRIVE (+)
DRIVE ( )
Connector
Pin No.
MECHANICAL CONNECTION
Before mounting any lens onto this camera, check that the rear lens dimensions do not exceed the following
maximum length, otherwise CCD imager could be damaged.
The camera is shipped, ready to accept “CS“ type lens. If standard “C“-mount lens are to be used, it is necessary
to install the “C-mount Adapter“ ring first, then the lens.
“X”
CS = 0.2" (6 mm)
C = 0.4" (10 mm)
"X" LENS
Fig.3
En-7