Fisher-Price MX3 73535 - Manual (Page 8)

Assembly
• Wrap the plastic tie around the brake cables, power
wires and the handlebar.
• Insert the flat end of the plastic tie into the opening
in the square end of the plastic tie. Pull the flat end of
the plastic tie with pliers to be sure it is tight around
the handlebar.
• Using safety scissors, cut off the excess plastic tie.
Throw the excess plastic tie away.
8
7 Handlebar
Brake Cables
Power Wires
Cut off
Excess
Plastic Tie
• While holding the lock nut with an adjustable wrench
(or a 7 /
16
" wrench), tighten the bolt with the Allen wrench.
Do not over-tighten.
• Check to be sure the handlebar is securely attached.
Lift it and push it from side to side. It should not move.
If it does move, tighten the bolt a few more turns with
the Allen wrench.
• Repeat steps 5 and 6 to fasten the other handlebar to
the front fork with a 1 9 /
16
" bolt and 7 /
16
" lock nut.
6
Allen Wrench
Adjustable Wrench
• Lift a handlebar to align the hole in the handlebar with
the hole in the front fork.
• Insert a 1 9 /
16
" screw through the outer edge of the
front fork, handlebar and then out the inner edge of
the front fork.
• Attach a 7 /
16
" lock nut (rounded edge outward) to the
end of the screw and hand-tighten it.
5
1 9 /
16
" Bolt - 2
7 /
16
" Lock Nut - 2
BOTH SHOWN ACTUAL SIZE
Rounded Edge