Gefen Extender DVI 1600HD - Manual (Page 13)

10
How to Connect the DVI 1600HD Extender
1. Connect the DVI or HDMI (using a HDMI to DVI adapter/cable) to the DVI
1600HD Extender sending unit using a user supplied cable.
2. Connect up to 3 audio sources to the sending unit using user supplied
cables. Input options are as follows:
Analog stereo using one pair of RCA analog stereo cables.
Digital coaxial using one S/PDIF digital coaxial audio cable.
Digital optical using one TOSLINK digital optical audio cable.
3. Optionally, connect an RS-232 device to the sender unit using a user
supplied RS-232 cable.
NOTE: The DVI 1600HD Extender system will not cross the transmit and
receive lines as a null-modem adapter would. All pins will pass straight
through from one point to the other.
4. Connect 2 pairs (4 strands) of LC terminated single or multi-mode fi ber
optic cables to the sender unit. Connect the opposite ends of the fi ber optic
cabling to the receiver unit’s fi ber optic receptacles.
5. Connect a DVI or HDMI (using a DVI to HDMI adapter/cable) capable device
to the DVI output of the DVI 1600HD Extender receiving unit using a user
supplied cable.
6. Connect up to 3 of the audio outputs to audio receiving devices. Available
outputs are as follows:
Analog stereo using one pair of RCA analog stereo cables.
Digital coaxial using one S/PDIF digital coaxial audio cable.
Digital optical using one TOSLINK digital optical audio cable.
NOTE: All outputs are active regardless of the selected input on the sender.
However, multi-channel content that is being sent by the digital connectors
will not be output by the analog stereo output.
7. Optionally, connect an RS-232 device to the receiver unit using a user
supplied RS-232 cable.
8. Connect the included 12V DC power supplies to both the sending and
receiving units and open wall power sockets.
9. Power on the endpoint device fi rst and then the source device.
CONNECTING THE DVI 1600HD EXTENDER