GE GRD33G3A - Manual (Page 55)

REFERENCE
53
Programming the Remote to Control a Cable Box
1. Turn on the cable box.
2. Look up your brand and its code number(s) in code list on
page 55.
3. Press and hold the ALT button.
4. Press and release the DSS ® button.
5. Enter the three-digit code from the code list.
6. Release the ALT button and press ON•OFF or CHAN UP or
DOWN to see if the cable box responds to the remote
commands.
7. Repeat these steps using the next code listed for your brand
until the cable box responds to the remote commands.
Programming the remote to control a laserdisc player
1. Turn on the laserdisc player.
2. Look up your brand and its code number(s) on code list on
page 55.
3. Press and hold the ALT button.
4. Press and release the VCR button.
5. Enter the three-digit code from the code list.
6. Release the ALT button and press ON•OFF or another button
to see if the laserdisc player responds to the remote
commands.
7. Repeat these steps using the next code listed for your brand,
until the laserdisc player responds to the remote commands.
Using the Remote Buttons to Control a
Device
Once the remote has been programmed with the correct codes,
you are ready to use it to control your devices.
To operate the device:
1. Press the device button (TV, DSS ® , VCR, or ALT) to set the
remote to control the device.
2. Press OFF•ON to turn the device off or on.
3. Use the remote buttons that apply to that device.
This remote may not operate all
models of the brands that are
shown. Use the codes shown in this
manual, or on the sheet packed with
your remote.