GE 24962 - Manual (Page 10)

10
Using Your Remote
Controlling Devices with Separate
Power On and Off Buttons
Some GE, RCA and ProScan models require
you to press the device button for more than one
second to turn the device on and the POWER
button to turn the device off.
Controlling Combo Devices
Some Combo devices (e.g., TV/DVR, TV/DVD,
DVD/DVR, etc.) will require you to set up two
different Mode buttons to control both parts of the
Combo device. For example, if you have a TV/
DVD Combo, you might need to set up one code
under the TV button to control the TV part AND a
separate code (under any other Mode button) to
control the DVD part.
DVR/DVD Punch-Through
This remote allows the 6 DVD/VCR transport
buttons (i.e. PLAY, PAUSE, STOP, FF, REWIND,
and REC) to Punch-through from any Mode
programmed with TV, SAT or Cable codes to the
last DVD, or VCR programmed Mode you used,
i.e., the transport keys control your DVD or VCR
player even when you are in TV, SAT or Cable
mode. If you use a SAT/DVR, Cable/DVR, etc., you
may want to disable this Punch-through feature
to allow the transport keys to control your DVR
device. The following steps will disable the punch-
through feature:
1. Press and hold SETUP until the red indicator
stays on, then release the SETUP button.
2. Press and hold PAUSE until the red indicator
turns off, then release the PAUSE button. The
PAUSE button needs to be held held for about
3 seconds before the red indicator turns off.
The punch-through feature can be enabled again
by repeating the above steps.