GE 24962 - Manual (Page 7)

7
Direct Code Entry
Write your codes down here for easy reference
later.
1. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
2. Press and release the desired mode
button ( TV, DVD, etc.). The red indicator
blinks, then stays lit.
3. Enter the 4-digit code
from the code tables
(on separate sheet).
Note: after a valid code
entry, the red indicator
turns off. For an invalid
code, the red indicator
flashes.
4. With your device on, press ON/
OFF. If the device turns off, no
further programming is required.
Note: If some buttons do not
operate your equipment, try one
of the other codes for your brand.
Device Device stored Code
TV TV
DVD
SAT/CBL