Stovax AR0368 - Manual (Page 13)

13
4.2 Locate the front coal moulding in front of the flame baffle
ensuring that the end legs sit flat against the burner skin, see
diagram 11.
4.3 Place three large coals on the front coal so that they lean
against the flame baffle, and the four large coals on the
flame baffle so that they sit on the fingers, see diagram 12.
4.4 Place two small coals at each end of the front coal so that
they lean against the flame baffle, and a further two large
coals on the flame baffle, one at each end, see diagram 13.
4.5 Place five small coals along the rear of the flame baffle,
resting against the rear ledge, see diagram 14.
4.6 Ensure that the rope seal on the back of the glass frame is
intact. Replace the glass frame ensuring that the 6 screws are
tightened evenly. DO NOT OVERTIGHTEN. see diagram 15.
NEVER OPERATE THE STOVE WHEN THE DOOR IS
REMOVED OR WHEN THE GLASS IS BROKEN.
4.7 Secure the glass frame assembly using the 6 screws
provided, tighten evenly and do not overtighten. See
diagram 15.
4.8 Hang the dcorative steel trim onto the glass frame as shown.
See diagram 17
5.1 Full instructions are given in Section 2.
INSTALLATION INSTRUCTIONS
INSTALLATION
11
AR0366
12
AR0367
13
AR0368
14
AR0369
15
AR0887
17
5. LIGHTING