GE 200D8074P044 - Manual (Page 23)

23
Installation Instructions
PUT THE REFRIGERATOR
IN PLACE
Move the refrigerator to its final location.
4
LEVEL THE REFRIGERATOR
The refrigerator can be leveled by
adjusting the rollers located near the
bottom hinges.
Rollers have three purposes:
• Rollers adjust so the door closes easily
when opened about halfway. (Raise the
front about 5/8” [16 mm] from the floor.)
• Rollers adjust so the refrigerator is
firmly positioned on the floor and does
not wobble.
• Rollers allow you to move the
refrigerator away from the wall
for cleaning.
To adjust the rollers:
• Turn the roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise
to lower
it. Use
a 3/8” hex socket
or wrench, or
an adjustable
wrench.
5
Rollers
Roller adjusting screw
LEVEL THE DOORS
Adjust the refrigerator door to make the
doors even at the top.
To align:
Using a 7/16” wrench, turn the door
adjusting screw to the right to raise the
door, to the left to lower it.
NOTE:
A nylon plug, imbedded in the threads
of the pin, prevents the pin from turning
unless a wrench is used.
After one or two turns of the wrench,
open and close the refrigerator door and
check the alignment at the top of the doors.
6
A
B
Doors should be even at top
Raise
7/16” wrench
Raise
SCREW DOWN SUPPORT LEG
Screw down the support leg until it
touches the floor. This will prevent door
misalignment.
7