Broiling feature, Broiling feature , 17, Using the broiling feature – GE JGRP20 User Manual

Page 16

Advertising
background image

16

Operating Instructions

Safety Instructions

Consumer Support

Tr

oubleshooting T

ips

Q. Are there blue flames on both sides of

the broil burner?

A.

Yes, but the bright orange glow of the
burner igniter may make the flame
difficult to see. If you cannot see the
flame on both sides and feel your
broil burner is not functioning
properly, try the “toast test.”

Q. When broiling, is it necessary to

always use a grid in the pan?

A.

Yes. Using the grid suspends the meat
over the pan. As the meat cooks, the
juices fall into the pan, thus keeping

meat drier. Juices are protected by the
grid and stay cooler, thus preventing
excessive spatter and smoking.

Q. Should I salt the meat before

broiling?

A.

No. Salt draws out the juices and
allows them to evaporate. Always salt
after cooking. Piercing the meat with
a fork allows juices to escape. Turn
the meat with tongs instead of a fork.

How to Set Your Oven for Broiling

Touch the BROIL HI/LO pad.

Touch the BROIL HI/LO pad again
(alternates between LO Broil and
HI Broil).

Touch the START pad.

Touch the CLEAR/OFF pad when
broiling is finished.

Before You Begin Broiling…

If the meat has fat or gristle around the
edge, cut vertical slashes through it about
2

″ apart. If desired, the fat may be trimmed,

leaving a layer about 1/8

″ thick.

Place the meat on any broiler grid in a
broiler pan. Always use the grid so the fat
drips into a broiler pan; otherwise the
juices may become hot enough to catch
on fire.

Position any broiler pan on a rack on the
recommended rack position as suggested in
the Broiling Guide. Place the sump area of
a broiler pan to the front of the door.

NOTE: Always broil with the oven door closed.

Turn the food using tongs only once during
broiling. Time the foods for the first side
according to the Broiling Guide.

Turn the food, then use the times given for
the second side as a guide to the preferred
doneness.

To test if your broiler is working properly:
Cover an entire broiler pan grid with bread.
Place any broiler pan on the third rack
from the bottom. Broil until the bread is
golden brown. If you have browning on
both sides of the pan, your broiler is
working properly. If toast browns only on
one side of the pan, call for service.

Using the broiling feature.

GEAppliances.com

Broiling is cooking food by direct heat from above the food. Most fish and tender cuts of meat can be broiled. Follow
these directions to keep spattering and smoking to a minimum.

Questions and Answers

Advertising