Grundig YB550PE - Manual (Page 10)

QUICK GUIDE continued 3 DETAILED OWNERS MANUAL
D E L E T I N G M E M O R I E S A N D M E M O RY
PA G E S
To delete a frequency stored in a memory, press/release the
M.Scan/Page button, then use the +/- buttons to select the
memory preset location of the frequency that you wish to
delete. Then press/hold the Mem./Edit button for about 2 sec-
onds and then release it. ‘dEL’ appears flashing in the display.
Within 2 seconds, press/release the Mem./Edit button. To
delete all contents of a page, press/release the M.Scan/Page
button, then press/hold the Mem./Edit button for 4 seconds
and then release it. ‘dEL’ appears flashing in the display.
Within 2 seconds, press/release the Mem./Edit button.
L E A R N I N G M O R E A B O U T T H E Y B 5 5 0 P E
All of the YB 550PE’s capabilities cannot be addressed in this
Quick Guide. You can tailor the radio to your own liking with
System Set Codes. To do this, see the section titled SYSTEM
SET CODE TABLE, pages 41-42.
19 18
YB 550PE OPERATION MANUAL
NOTE: In the instructions below, numbers in parenthesis ( ),
refer to the diagrams and appear only at the first use or
description of the item. See the previous section titled
DIAGRAMS.
INSTALLING BATTERIES
Install 3 AA alkaline batteries into the battery compartment
(21), observing the battery polarity diagram on the back of
the radio. To remove the battery compartment cover, first
remove the STAND (20) by pulling its locking tabs away from
the lower sides of the radio and then removing it from the
back.
USING RECHARGEABLE BATTERIES: Rechargeable bat-
teries must be charged in their own charger. They will not
charge inside the YB 550PE.We suggest nickelmetal-hydride
batteries (Ni-MH). Be sure to change the SYSTEM SET CODE
accordingly. See the section titled SYSTEM SET CODE TABLE,
on pages 41-42.