Led work area light, Using the drill, Forward/reverse switch – Global Machinery Company GTX2450K User Manual

Page 10: Drilling positions, Torque adjustment/hammer selection collar, 2 speed gearbox

Advertising
background image

10

LED Work area light

The drill has 3 LED lights (11)

to illuminate the work area and

improve vision when drilling in

areas with insufficient light.
To turn the LED lights on and

off depress the LED light switch

(13).

Using the drill

Use the forward/reverse switch (4) to select the direction

of rotation, then pull the trigger (3). This trigger switch is

an electronic variable speed control which enables the user

to vary the speed continuously. The speed varies according

to how far the trigger switch is depressed, the further it is

depressed the faster the chuck will rotate and the lighter it

is depressed, the slower it will rotate.
To stop the drill, release the trigger switch.

Note.

You can only change the direction of rotation of the

drill using the forward/reverse switch when the trigger is

NOT depressed.

Forward/reverse switch

This switch (4) will allow you

to change the direction of

the motor while the trigger

switch is not depressed.
Drilling uses the forward mode.

The reverse mode is intended for

the removal of screws.

Drilling positions

This symbol indicates the DRILLING MODE. Used for

all normal drilling (Wood, Aluminium, and Steel) in

this mode the clutch is deactivated.
This symbol indicates the HAMMER MODE. This mode

will activate hammer action, whilst drilling. For best

results in hammer mode, set the gear selector to

high gear.

Torque adjustment/hammer selection collar

By rotating the torque adjustment/hammer selection collar

(2) behind the chuck, it is possible to adjust the torque to

each of nineteen settings, or select hammer action or the

drill setting.
The range of nineteen torque settings allows better control

when using the drill as a screwdriver as it prevents over-

tightening of the screws.
The symbols circling the collar are used to indicate the

level of torque. The larger the symbol on the collar, the

higher torque and the larger the fastener which can be

driven. To select any of the symbols, rotate the collar

(2) until the desired symbol aligns with the arrow head

indicator on the housing.

2 Speed gearbox

The 2 Speed Gearbox allows

you to select a gear with the

optimum speed and torque to

suit the application.

Note.

When changing the gear

selector ensure the drill is not

operating.
1. To select the LOW gear (low speed, high torque setting),

push the gear selector (9) forward, towards the chuck.

The word LOW will be displayed.

2. To select the HIGH gear (high speed, low torque

setting), push the gear selector (9) back, away from the

chuck. The word HIGH will be displayed.

Advertising
This manual is related to the following products: