GE 49-7419-2 - Manual (Page 16)

Installation Instructions
16
UTILITY CLOSET CONNECTION LOCATIONS
IMPORTANT:
Plan and locate plenum, wall plug, drain and
thermostat carefully to avoid interference. Hard-to-reach locations
will make installation and service difficult!
Reference Dimensions
A Thermostat cable: 9 1 ⁄
2
′ long
B Power cord: 60
″ long
C Case width and depth: 23 1 ⁄
8
″
D Case height: 31
″
E Condensate drain: 3/4
″ connector
(Centerline of cutout is approximately 5 1 ⁄
4
″ from
left case wall and 8 1 ⁄
2
″ from back case wall.)
F Typical wall plug: 6
″–12″ above case
G Room air sensor kit: 10
′ long
Outside wall
Flex duct may be used
for transitions only
Use rigid duct for 90°
bends and tees
F
C C
D
E
Platform
B A
230/208 VAC
wall receptacle
or
conduit for direct
connection
G
5 1 ⁄ 4
″
8 1 ⁄
2
″