Graco SnugRide 1760658 - Manual (Page 41)

41
1. For ease of storing, extend
LATCH to its maximum length.
2. Locate the storage bars on
bottom of infant restraint base
➌.
3. Fasten connector (without
adjustment belt) onto storage bar.
4. Repeat step 3 for connector with
adjustment belt. After fastening
onto storage bar, pull on
adjustment belt to make sure
LATCH is securely fastened.
5. LATCH storage should look
like this when complete
➌.
8.1 Airplane Use
When installing in an airplane using the
base, install the same way as in an
automobile with a lap only belt leaving the
lock off fully opened to allow for buckle
clearance. If using the shell only installing
follow the same instructions as an automobile. Notify the airline
ahead of time that you intend to bring the seat on board.
Use only in forward-facing aircraft seat. Follow the flight
attendants instructions about infant restraint placement.
Do not use this infant restraint if the airplane seat belt does
not hold the infant restraint securely.
8.0 Ad
ditional Inf
ormation
➌
Storage bars
8.2 Storing LATCH
Underside of base