GE 840092600 - Manual (Page 8)

8
IMPORTANT: When using
the continuous feed chute
the food gate must be
removed and the continuous feed
disc must be in place.
1. Make sure the Control Switch is
turned to OFF and the unit is
unplugged.
2. Lock the bowl onto base. (See “How
to Lock the Bowl” on page 5.)
3. Place the continuous feed disc, ribbed
side up, onto the motor shaft. Turn
the disc slowly until it drops into
position (level with top of bowl).
4. Select desired side of reversible
slicing/shredding disc and place that
side up on the motor shaft.
5. REMOVE FOOD GATE FROM
CONTINUOUS FEED CHUTE TO
PREVENT DAMAGE TO UNIT.
6. Lock on cover. (See “How to Lock the
Cover” on page 5.) Place bowl under
feed chute.
7. Plug in unit and select speed. Process
food. Check the continuous feed
chute frequently to make sure the
opening is not blocked. If blocked,
turn unit off and unplug. Clear
blockage, then reassemble and
continue processing.
NOTE: When using the continuous feed
chute, some food may fall into the food
processor bowl.
Hint!
Do not use the continuous feed chute
feature when shredding root vegetables
such as carrots and potatoes. As with
most continuous feed processors, the
shredded moist vegetables may clog in
the chute. It is best to shred these
vegetables into the food processor
bowl. Slicing these root vegetables
while using the continuous feed chute
will not present a problem.
Continuous
Feed Disc
Motor Shaft
Slicer/Shredder
Disc
Motor Shaft
Continuous Processing
840092600 Ev01.qxd 4/9/02 8:36 AM Page 8