Grizzly G4030 - Manual (Page 20)

-18- G4030 6 1 ⁄
2
" x 10" Metal-Cutting Bandsaw
Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving
machinery.
Operation Safety
SECTION 4: OPERATIONS
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
The vise can hold material up to ten inches wide
and be set to cut angles up to 45 degrees.
To adjust the angle on the vise:
1. Loosen the lock nut with a 12mm hex wrench
or socket as shown in Figure 13.
2. Use the scale as a guide to set your angle or
use a machinist square to square the blade
to the vise as shown in Figure 14.
3. Tighten the lock nut.
Figure 13. Setting vise angle.
Vise
Figure 14. Squaring vise to blade.