GN Netcom E2555 - Manual (Page 19)

35
Appendix
34
Appendix
“Beep”
(Single beep) Handset registration or programming
command successfully completed.
“Beeeeeeeeep”
(1 long beep) The handset is out of range. Move closer
to the base.
“Beeeeeeeeep”
(1 long beep) Error tone (current operation has been
unsuccessful; try again).
Alert tones and indicator lights
“Beep-Beep-Beep-Beep-Beep”
(5 quick beeps) Handset battery is low. Place handset in
base to charge the battery.
Alert tones
Indicator lights
MUTE
On when base
microphone is muted.
SPEAKER
On when speakerphone
is in use
Display screen status icons
Handset status icons
Phone in use (external call)
Phone in use (intercom call); flashes when handset is being paged
Battery power level (see below)
Ringer off
R Handset is not yet registered, or searching for base
Base status icons
Battery power level (see below)
Ringer off
Battery power levels
Battery fully charged
Approximately half power remaining
Battery power is low; should be recharged soon
(flashing) Battery power is very low and must be recharged
1
Answering system is receiving an incoming call
Handset identification number
M Microphone is muted
H Call is on hold
T
ON/OFF
On when answering
system is on.
NEW MESSAGES
Flashes when new
messages are waiting
HANDSET 1
REDIAL MEM MENU
REDIAL MEM MENU