Global Machinery Company MX1G100 - Manual (Page 6)

6
• Periodically check that all nuts, bolts and other fixings are
properly tightened.
• When using the drill, use safety equipment including
safety glasses or shield, ear protectors, and protective
clothing including safety gloves. Wear a dust mask if the
drilling operation creates dust.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful to
the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool’s construction and
design:
• Damage to the lungs if an effective dust mask is
not worn.
• Damage to hearing if effective ear protectors are
not worn.
Contents of carton
• Auxiliary handle
• Depth gauge
• 100 Drill and Bit accessories
12 x HSS drill bits
- 2 each of 2mm, 3mm, 4mm, 5mm, 5.5mm
and 6mm
6 x Wood drill bits
- 2 each of 4mm, 5mm & 6mm
66 x 25mm Screwdriver bits
- 3 each of slotted bits 3mm, 4mm, 5mm, 5.5mm,
6mm and 7mm
- 3 each of phillips #0, #1, #2 and #3
- 3 each of pozi #0, #1, #2 and #3
- 1 each of star T10,T15,T20,T25,T30 and T40
- 1 each of square S0,S1,S2 and S3
- 1 each of hex metric 2mm, 2.5mm, 3mm, 4mm,
5mm, 6mm and 7mm
- 1 each of hex imperial 5/64”, 3/32”, 1/8”, 5/32”,
3/16”, 1/4” and 9/32”
6 x 50mm Screwdriver bits
- 1 each of slotted 4mm, 5mm and 6mm
- 1 each of phillips #1, #2 and #3
9 Nut drivers
- 1 each of 5mm, 6mm, 7mm, 8mm, 9mm,
10mm, 11mm, 12mm and 13mm
1 Screwdriver bit holder
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.